QQmlWebSocketMessages can only be sent when the socket is open.只有在套接字打开时才能发送消息。QQmlWebSocket is not ready.QQmlWebSocket未准备好。QQmlWebSocketServerQQmlWebSocketServer is not ready.QQmlWebSocketServer未准备好。QWebSocketConnection closed连接已关闭Invalid URL.无效的URL。Invalid resource name.无效的资源名。SSL Sockets are not supported on this platform.此平台不支持 SSL 套接字。Out of memory.内存不足。Unsupported WebSocket scheme: %1不支持的 WebSocket 方案: %1Error writing bytes to socket: %1.写入套接字时出错: %1。Bytes written %1 != %2.写入的字节数 %1 != %2.QWebSocketPrivate::processHandshake: Unsupported WWW-Authenticate challenge encountered.'WWW-Authenticate' is the HTTP header.QWebSocketPrivate::processHandshake: Unsupported WWW-Authenticate challenges encountered.Header is too largeRead handshake request header failedRead handshake request status failedParsing handshake request header failedWebSocket server has chosen protocol %1 which has not been requestedInvalid parameter encountered during protocol upgrade: %1Invalid statusline in response: %1.响应的状态行无效: %1.QWebSocketPrivate::processHandshake: Connection closed while reading header.QWebSocketPrivate::processHandshake: 读取标题时连接关闭。Accept-Key received from server %1 does not match the client key %2.从服务器 %1 收到的Accept-Key与客户端密钥 %2 不匹配。QWebSocketPrivate::processHandshake: Invalid statusline in response: %1.QWebSocketPrivate::processHandshake: 响应的状态行无效: %1.Handshake: Server requests a version that we don't support: %1.Handshake: 不支持服务器请求的版本: %1.QWebSocketPrivate::processHandshake: Unknown error condition encountered. Aborting connection.QWebSocketPrivate::processHandshake: 出现未知错误。取消连接。QWebSocket::processHandshake: Host requires authenticationQWebSocketPrivate::processHandshake: Unhandled http status code: %1 (%2).QWebSocketPrivate::processHandshake: 未处理的 http 状态码: %1 (%2).The resource name contains newlines. Possible attack detected.资源名称中有空行。检测到可能的攻击。The hostname contains newlines. Possible attack detected.主机名称中有空行。检测到可能的攻击。The origin contains newlines. Possible attack detected.原文有空行。检测到可能的攻击。The extensions attribute contains newlines. Possible attack detected.扩展属性中有空行。检测到可能的攻击。The protocols attribute contains newlines. Possible attack detected.协议属性中有空行。检测到可能的攻击。Connection refusedQWebSocketDataProcessorReceived Continuation frame, while there is nothing to continue.收到了一个延续帧，但相应的帧不存在。All data frames after the initial data frame must have opcode 0 (continuation).初始数据帧之后的所有数据帧的操作码必须为 0（连续帧）。Received message is too big.收到的消息太大。Invalid UTF-8 code encountered.检测到无效的 UTF-8 代码。Payload of close frame is too small.关闭帧的有效载荷太小。Invalid close code %1 detected.无效的关闭代码 %1。Invalid opcode detected: %1检测到无效的操作码: %1Timeout when reading data from socket.从套接字读取数据时超时。QWebSocketFrameTimeout when reading data from socket.从套接字读取数据时超时。Waiting for more data from socket.Error occurred while reading header from the network: %1Error occurred while reading from the network: %1从网络读取时出错: %1Lengths smaller than 126 must be expressed as one byte.小于 126 的大小必须用 1 个字节表示。Something went wrong during reading from the network.从网络加载时出现问题。Highest bit of payload length is not 0.有效载荷长度的最高有效位非0。Lengths smaller than 65536 (2^16) must be expressed as 2 bytes.小于 65536 (2^16) 的大小必须用 2 个字节表示。Error while reading from the network: %1.从网络读取时出错: %1。Maximum framesize exceeded.超出最大帧大小。Some serious error occurred while reading from the network.从网络加载时发生严重错误。Rsv field is non-zeroRSV 值不为 0Used reserved opcode使用保留的操作代码Control frame is larger than 125 bytes控制帧大于 125 字节Control frames cannot be fragmented控制帧不能拆分QWebSocketHandshakeResponseAccess forbidden.访问被拒绝。Unsupported version requested.请求的版本不支持。One of the headers contains a newline. Possible attack detected.标头中有一个空行。检测到可能的攻击。Bad handshake request received.收到无效的握手请求。QWebSocketServerServer closed.服务器已关闭。Header is too large.Too many pending connections.等待中的连接太多了。Read handshake request header failed.Upgrade to WebSocket failed.升级到 WebSocket 失败。Invalid response received.收到无效回复。